Can Present Sensor with Quick Connect electrical This M8 3-wire connector cable

This M8 3-wire connector cable is used with most Wild Goose Filling systems and has one molded female end and three wires on the other

Seam rotary sensors are not used with Gosling seamers but they ARE used on the fill head raised cylinder on all V2 Gosling units

This four pin connecting cable is 5m (16

Lane 2 part length - Approximately 3

Can Present Sensor with Quick Connect electrical This M8 3-wire connector cableThe can present sensor is used on all EVO and WG8 10 systems and comes with an assembled 3 wire quick connect Commonly referred to as "First and Last can sensors", this inductive proximity sensor is used to detect the presence of a can at the first fill head and last CO2 purge tube. An additional can present sensor is found near the seamer's entrance. A can must be present at these sensors for the filling seaming cycles to start.