TPM - Wash Solvent - 20L CYBER MONDAY Dimensionally stable

Dimensionally stable

You can combat this by increasing retraction and playing with the heat temperature

two new pins are placed close to the reset pin

Mark Point Collage

TPM - Wash Solvent - 20L CYBER MONDAY Dimensionally stableWash Solvent TPM Wash Solvent (Tripropylene glycol monomethyl ether) is a non flammable, low odor solvent that can be used to clean and dissolve uncured resin on SLA DLP 3D printed parts. TPM has a lower evaporation rate than IPA and washes about three times as many parts as IPA before it needs to be replaced. * Compatible with Formlabs Finish Kit, Form Wash and Form Cure * 20 litres ! ATTENTION ! TPM is not currently certified for use with Formlabs