UltiMaker - S-Line Feeder Left Assembly (Fine Knurl) - UMS3/S5 3DE ABS Polycarbonate prints better on satin

Polycarbonate prints better on satin compared to smooth and structured printed circuit boards

Onboard SPI interface for connecting acceleration sensor to enable Klipper's input shaping

If a camera is connected

Supported filaments: PLA

UltiMaker - S-Line Feeder Left Assembly (Fine Knurl) - UMS3/S5 3DE ABS Polycarbonate prints better on satinFine Knurl Feeder left assembly (Feeder 1) for UltiMaker. Please note: compatible with UltiMaker S3 S5 models only. This version of feeders is installed by default on all UltiMaker S5 printers with a serial number starting with BPP 030368 and higher, or that have the Fine Knurl Feeder Kit installed. If replacing the Course Knurl Feeder, both the right and left feeders must be updated at the same time Article number: 225720