RGB LED Strip Driver Shield v1.0 Category_Robot Kits/BEAM problematic

problematic

so you should not use the current measured at the power supply to set the current limit

support sleep mode

The pins are normally open (disconnected)

RGB LED Strip Driver Shield v1.0 Category_Robot Kits/BEAM problematicWant to program your RGB LED strip to be a bit more "rhythmic" or "unpredictive"? This RGB LED Strip Shield contains all the components you need to build a super cool RGB (or other three channel) LED project with your Arduino . The shield has 3 outputs with pulse width modulation. Each can control any 12V load, at up to 3A. The shield has build in IR receiver which allows the LED strip to be controlled by an IR remote controller . A buildin fuse